ref.VDBX.io
  • Welcome
  • Terminal (sh)
    • MacOS (zsh)
    • Disk Recovery
  • Klipper
    • Install Firmware
    • Input Shaper
  • Docker
  • Software
    • ESPHome
      • Web Installer
    • Lists & Sources
    • Brew
    • Flood for Transmission
      • Mac
    • UTM
  • Raspberry Pi
  • VenusOS
  • Proxmox
  • Unifi
  • Mullvad
  • Speedify
  • Mikrotik
  • Home Assistant
Powered by GitBook
On this page
  • Start/Stop Klipper via SSH
  • Get connected MCUs
  • Weird Policy Bug after upgrade
  • Rotation Distance:
  • PID Autotune
  • Pressure Advance
  • Refs

Klipper

Start/Stop Klipper via SSH

sudo service klipper start/stop

Get connected MCUs

ls /dev/serial/by-id/*

Weird Policy Bug after upgrade

./scripts/set-policykit-rules.sh
cd ~/moonraker \
git pull \
./scripts/install-moonraker.sh -r

https://github.com/Arksine/moonraker/issues/352

Rotation Distance:

https://github.com/mplogas/Klipper_SKR_PRO_TMC2209_Ender5/blob/master/extruder_volcano.cfg

PID Autotune

PID_CALIBRATE HEATER=extruder TARGET=235
PID_CALIBRATE HEATER=heater_bed TARGET=60

Pressure Advance

SET_VELOCITY_LIMIT SQUARE_CORNER_VELOCITY=1 ACCEL=500
TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.005

Run square_tower.gcode - reslice for current settings/nozzle size

  • PA Settings

    • 0.6mm: 0.035

    • 0.4mm: 0.088

TODO:

  • Input Shaper

  • Pressure Advance

  • Redo X/Y/Z size calibration

Refs

PreviousDisk RecoveryNextInstall Firmware

Last updated 1 year ago

https://github.com/th33xitus/klipper_config/tree/cd6052284861b57bfc51dc5c94824f99ec2dd4df/macros